What progression actually is

Progressive overload is the slow increase in what you ask of a muscle: the same exercise, meaningfully harder than it was a month ago. That is the whole principle. Everything else — the spreadsheet, the percentages, the RIR targets — is bookkeeping.

Where people go wrong is assuming “progression” means “more weight every session.” That works for a few months when you are new, then stops, and the people who keep getting stronger for years are the ones who learned the other dials before they needed them.

The five dials

Every exercise gives you five ways to make it harder. They are not interchangeable in cost, which is why the order matters.

What you can progress, and what each one costs
DialWhat it meansThe cost
LoadSame reps, more weightHighest joint and connective-tissue demand; smallest room for error
RepsSame weight, more repsSets get longer; fatigue per set rises
SetsMore weekly volume for a muscleTime, and recovery that has to be paid back
Range of motionDeeper, cleaner reps at the same loadRequires control; exposes weak positions
Proximity to failureEnding closer to your limitMuch more fatigue for a small extra stimulus

Load or reps? Someone tested it

Forty-three people with at least a year of consistent lower-body training were split into two groups for eight weeks. Both did four sets of four lower-body exercises twice a week. One group increased the load while keeping reps the same; the other increased reps while keeping the load the same.[2]

Quadriceps growth came out very slightly in favour of the rep group (2.8 mm across the measured sites, 90% CI −0.5 to 5.8) and strength very slightly in favour of the load group (2.0 kg, 90% CI −2.4 to 7.8). Both intervals cross zero, which in plain language means: no clear winner. The authors' conclusion was that both are viable ways to run an eight-week block.[2]

The practical version: pick the one you can measure honestly. If your gym has 2.5 kg jumps, adding a rep is often the smoother path; if the equipment is dialled in 1 kg at a time, load is easy to track. Either way, write it down — progression you cannot remember is progression you cannot repeat.

The 2–10% rule

The American College of Sports Medicine's guidance has survived two decades because it is boring and it works: when you can perform your current workload for one to two repetitions over the target, add 2–10% to the load.[1]

Read the precondition carefully, because it is where most people break it. The rule assumes you are at the top of your rep range with good form and only 1–2 reps spare. Adding 10% to a set of 8 where you actually had 5 left in the tank is not the rule. It is a shortcut to the physio.

Practical translation: a 100 kg squat at the top of its rep range becomes 102–110 kg. In a gym with 2.5 kg increments, that is one or two small jumps — which is exactly the point. Small, frequent, boring steps are easier to repeat than rare heroic ones.

Let the day decide

A fixed weekly percentage assumes your body behaves like a spreadsheet. It doesn't — sleep, food and stress move your capacity around by more than 2–10% on any given day.

In one trial, 23 Division I football players were trained for six weeks either with autoregulation — loads chosen from that day's performance — or with traditional linear progression, where the load went up on schedule regardless. The autoregulated group improved bench press 1RM by 93.4 N while the linear group changed by −0.4 N (p = 0.02), and improved squat by 192.7 N against 37.2 N (p = 0.05).[3]

Treat that with care: it is 6 weeks, 23 athletes, and the two groups trained in different years rather than being randomised side by side in the same season. It is suggestive, not definitive. But it matches what everyone who has trained for a decade already knows — the plan is a starting point for the day, not a verdict on it.

Which is where reps-in-reserve earns its keep: decide the load after a warm-up set, not before. The RIR and RPE article covers how to judge that honestly.

Range of motion counts as overload

Completing a rep you used to cut short is making the exercise harder, whether or not the number on the bar changes. A meta-analysis of 16 studies found full range of motion produced greater strength gains than partial range (effect size 0.56, p = 0.004) and greater lower-limb hypertrophy (effect size 0.88, p = 0.027).[4]

That makes depth, pause and control legitimate progression. Going from a half squat to a full squat at the same weight is a genuine step up in difficulty — and usually a much safer one than adding 10 kg and keeping the shuffle.

Sets: the dial with a ceiling

Adding a set works, and it works more reliably than most of the things people argue about online. But it is a diminishing-returns dial: the more weekly sets a muscle already gets, the less each extra one buys. The dose–response literature is covered in detail in how many sets actually build muscle,[5] and the short version is that sets are the dial you turn when everything else has stalled — not the one you crank every week.

Effort: last, and in small doses

Training closer to failure is a form of overload too, and across the meta-analyses it is the weakest of the five: pushing sets nearer failure produced only a trivial additional effect on growth (effect size 0.19), while costing noticeably more recovery.[6] Use it to calibrate and occasionally to test, not as your weekly progression strategy.

When you stall

Stalling is information, not failure. Work down this list before you change programs:

How this shows up in your program

The workout builder runs a 12-week structure around exactly this: the first two weeks are calibration, where you find working weights with reps in reserve rather than chasing numbers; the next block is progression, adding reps before load; a deload week absorbs the fatigue; and the final re-test tells you what the block was worth.

The 1RM calculator is useful here for a different reason than it advertises: put in a set you just did and it tells you roughly what your max is now, so you can set next block's loads from something real instead of last year's estimate.

What we still don’t know

References

  1. Kraemer WJ, Adams K, Cafarelli E, et al. American College of Sports Medicine position stand. Progression models in resistance training for healthy adults. Med Sci Sports Exerc. 2002;34(2):364–380. PubMed 11828249
  2. Plotkin D, Coleman M, Van Every D, et al. Progressive overload without progressing load? The effects of load or repetition progression on muscular adaptations. PeerJ. 2022;10:e14142. PubMed 36199287
  3. Mann JB, Thyfault JP, Ivey PA, Sayers SP. The effect of autoregulatory progressive resistance exercise vs. linear periodization on strength improvement in college athletes. J Strength Cond Res. 2010;24(7):1718–1723. PubMed 20543732
  4. Pallarés JG, Hernández-Belmonte A, Martínez-Cava A, Vetrovsky T, Steffl M, Courel-Ibáñez J. Effects of range of motion on resistance training adaptations: a systematic review and meta-analysis. Scand J Med Sci Sports. 2021;31(10):1866–1881. PubMed 34170576
  5. Pelland JC, Remmert JF, Robinson ZP, Hinson SR, Zourdos MC. The resistance training dose response: meta-regressions exploring the effects of weekly volume and frequency on muscle hypertrophy and strength gains. Sports Med. 2026;56(2):481–505. PubMed 41343037
  6. Refalo MC, Helms ER, Trexler ET, Hamilton DL, Fyfe JJ. Influence of resistance training proximity-to-failure on skeletal muscle hypertrophy: a systematic review with meta-analysis. Sports Med. 2023;53(3):649–665. PubMed 36334240

Related reading

Want a progression plan that fits your lifts? Bring your last four weeks of training — what you lifted, what it felt like, what stalled — and I will set the next block around the dial you should actually be turning.

Work with me 1:1